Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Dear
I have a problem with clients flapping constantly, I have a WLC 2504 and I have the debug, I don´t find in the debug a complete DHCP process, also authentication is [WPA2][Auth(802.1X + CCKM)], but some things bad in the debug with PMKID:
*a...
Dear
We have problems in my wifi, I have WLC 2504 and 5 APs, however clients are experimenting flapping in the conexion, I verified with a client, and this one is jumping from one AP to other one, also I have some debug, you can see that in the attac...
Hello everybody,I have tried to found a report customized from WCS in order to get the number of clients connected to an Access Point. I have this information when I go by Configure --> Access Points (attached file with this info), there is the list...
Hello EveryoneI have a bit confussed with LDAP configuration in the controller cisco 5508, my client has a LDAP server, there are many users authenticated by LAN Network, if device is in Domain, users connected to wired network are authenticated with...
Hello everyoneI have configured layouts by TC Control for my codec sx80, my system has two cameras precision 60 and 3 displays, remote site has the same config two cameras and 3 displays just codec diferent (c90); remote site is sending two cameras ...
Dear all
pls comments about debug attached, also i would like share that there is a mix of APs 1242AG and 1602E, i dont know if exists a know problem about that. Pls thanks for your help.
