Hi everyone,
I have been playing around with various prefix list setups. Here I am using OSPF and I have attached the lab picture. I have attached the lab picture below.
For a intra-area prefix list I understand that just a distribute list is neede...
Hi,
I f anyone can help with this it would be wonderful. Here is my setup in a nut shell.
SWT2 (SG300 layer 2) ---[vlan 10 and 50 (mgmt)] --- SWT1 (SG300 layer 3) ----- Ubiquiti Router (SNTP time source)
Switch 1 has no issues getting its time ...
I cannot seem to figure how to add pictures to this forum so I apologize beforehand. I did include a attached screenshot.
Frame Relay setup:
R1/R2/R3:
172.12.123.0/24
R1 <----------------> R2
R1 <----------------> R3
Rest of network.
Fast ethernet ...
Hello There!
I have a fellow employee that sets up his phone port when the phone is the ONLY device as follows:
conf t
switchport access vlan 4
we use vlan 4 as the voice vlan. However when I set it up I always do the following.
conf t
switchport v...
Hi,First time post here. I would like some guidance if possible on troubleshooting redundant fiber links between 3 switches at the access layer and then a central switch at the distribution layer, which then goes to a router. All switches are just ...
Thanks Georg,
That is also true and a command I wasn't aware of. In this case however I was experimenting with using prefix-list across various protocols to try and get a better understanding. Sorry I didn't say that up front. Well now on to BGP...
Thanks Jon much appreciated! I guess if I understand correctly then, the lSA's shared in area 0 are always going to be the same and all routers will have the same information. Makes sense as I could look at the DB's and see every router knew the in...
Thanks Danny!
Yes exactly, instead of both switches pulling time from the router or pfsense as in Lee's situation I want SWT1 to also act as a NTP server also and send the time to SWT2 when it requests it. However I see no command to do that. Only ...
Well, I'm still hitting my head against the wall. I want SWT1 to get it's time from my router and well as broadcast it on vlan 50 my management vlan. Vlan 50 is the management that connects to the L2 switch and I don't want to change that. I've t...
