Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, Support community, I'm trying to deploy iWAN 2.2 in production for several branches. At this moment I have 2 Hub routers and 3 Branches with single router in each. Each routers have at least 2 connections to HUB site, for overlay networking iB...
Good day, dear communityI'm experiencing problem with acs 5.5 with installed latest patch. Suddenly secondary acs started to show problem which is shown on screenshot, everything is working fine, that's why is this message so strange for me, can anyb...
Finally decided to upgrade routers firmware and looks like it fixed the issue.
Software version used:
#sh ver | i IOS.*Version
Cisco IOS XE Software, Version 16.03.05
Cisco IOS Software [Denali], ASR1000 Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), V...
I don't think it could be related to speed negotiation, if you're using 10G ports on Cisco 3850, just ensure that they backward compatible with 1G interfaces.Did you tried mode passive on Cisco side?
Hello, each stack member should have its own crash folder. it depends on amount of members in your installation.
Try to find crashlog info using following command:
dir crashinfo-1:
Add required member number by yourself
