Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello CSC Problem DescriptionI have a C2811 GW with c2800nm-adventerprisek9-mz.151-4.M12a.bin and one VIC2-4FXO connected to a legacy 4xSIMs GSM GW for outbound calls to cel numbers. Each GSM GW FXS port is a SIM card, and each one is connected to a ...
Hello CSC, I want to know if there is a way to check CUCM LDAP sync status , also if there is a way to setup notifications (like for DRS on RTMT) when LDAP scheduled syncs end (to get evidence that syncs were done)
Regards.
Hello, I want to change some phones (7942,9971) on CUCM to register to a CME 8.6 for tests. However. following the common procedure on the phones of: Activate Alternate TFTP to the CME TFTP IPs , delete the trust list on the phones, and waiting that ...
Hello, reading this document (https://developer.cisco.com/site/sxml/learn/getting-started/risport/index.gsp#service-activation) I find that the link for Cluster service activation recommendations.is broken, and I need to know how to activate the SX...
Good Afternoon, I just want to know if there is a way to extract information of RTP streams when streams end and reoriginate there via MTP or TRP resources, even if its posible to enable RTCP in CUCM to take statistics of those streams at CUCM side, ...
Hello, today I could register the 7942 but only after register it first on CME as ephone , otherwise it went to register to CUCM again.
What I dont understand yet is why the CIPC persisted on registration process and didn't ended register on CUCM, me...
Hello, I just achieve the registration of CIPC on CME. In this case I saw that, even I have not configured the CIPC as ephone yet, it still persisted on registering state after I deleted the trust list and changed the TFTP addresses (as expected)
I'...
Hello, thanks for your answer. I was wondering in another method for extract RTP streams info besides CMRs or CUCM Traces, because CUCM CMR werent as accurate in our operation, and CUCM traces could be intensive in busy-hours.When you mention that we...
Ok, I understood, thats what I want to know, the five-tuple . I was thinking that could be important, as we have issues with CUCM CMRs that are reporting bad MOS's of calls around 2.0 or 3.0 , but even if I took EPCs for those calls and I didnt perci...
