Hi All,Calls from Analog PBX to CUCM Cisco phone cannot transfer back to another analog extension in same PABX (no voice)Exten 1 (PABX A)--->Cisco Phone (CUCM)--> Extension 2 (PABX A)Exten 2 can pick the calls originating from exten1 and transfer via...
Hi,I need a help to configure 4300 extension allow only to dial 4(0-3)XX range. and other extension should be blocked.Can we do it using access list config on call routing--> class of control --> access list. thanks.
Hi,i'm trying to send/receive fax using spa122 but it fail.our call path -FAX machine--->SPA122--->CUCM--(mgcp)->2921---> fxo--->PSTN direct linedoes it required any specific configuration than default mgcp configuration on router and fxo port config...
Hi Trying to register phone on srst gateway while disconnect the connection with cucm.Router g0/0 IP use as SRST ref. IP.able to see srts IP on ip phone as ucm 3 srst.phone not registering on router when disconnect the connection with cucmSRST versio...
Dear All,Is there any possibility to route E1 connection to separate PABX through Cisco 2921 voice gateway router? Telco----> 2E1(C2921 router)----> one for CUCM and one for Analog PABX. Thanks,
Hi Divina,PBX configured via sip trunk and manufacture is Teltronics.I didn't checked MTP required on trunk configuration and want to know how to configure MTP.Thanks.
Hi Amit,Route pattern configured with specific number (021248454) that i want to dial via FXO port and pointed to FXO port as gateway.when i dial to that number it will generate busy tone call route to the GW but not going through FXO port Thanks,
Hi Amit,now incoming fax is working having issue with send fax. I cant even dial to particular number from cucm extension may be issue is with the outgoing dial-peer assign to the voice-porthtsp_allocate_if --Mar 5 08:46:50.738: HTSP endpoint_info=...
