Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have installed am ATM module in a 2821 router, but I have no chance to put the command 'mode atm aim 1'murotuer(config)#controller E1 0/3/0myrouter(config-controller)#mode ? cas Configure CAS (Channel Associated Signal) mode ccs Configure CC...
We have now 12 channels but the problem is that we need 16 channels, but when I tried to configure it a message appears saying that we have no enough DSP memory. I tried to remove the ds0-group 0 to configure 16 timeslots but I can not. I have instal...
Hi, I have to replace the switch that is the vtp server and install a new one.the question is should I have to add to the newtwork the new one first and configure it as client and promote to server after the old has been disconnected?What are the ste...
I have installed a new ios and removed the old one but the switch can not start now.All I see is switch:I have tried to install a new IOS with the xmodem many times but always is aborted...is there any other way to load a new IOS to this switch?Regar...
I have 2 links (one primary) with eigrp and another one (backup) that I have to use BGP.Can anyone tell where can I find some info in order to configure this so the router will use BGP when the eigrp is down...Regards and thanks
Sorry, but I don't understand 'NAME: "8-port Analog Modem Card Version 2 on Slot 1", DESCR: "8-port Analog Modem Card Version' is for dial up access. I need to configure the ATM for the VWIC-2MFT-E1 card.Regards and thanks
Thanks for your answer, I have this router:Slot 0: C3845 Mother board 1GE(TX,SFP),1GE(TX), integrated VPN and 4W Port adapter, 5 portsPVDM Slot 0: 32-channel (G.711) Voice/Fax PVDMII DSP SIMM PVDM daughter card PCB Serial Number ...
This is what you are propossing?Router interface FastEthernet0/0 no ip address duplex auto speed auto interface FastEthernet0/0.1 encapsulation dot1Q 1 native ip address 10.10.10.15 255.255.255.0 no snmp trap link-status ! interface FastEthernet0/0.9...
