Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, I have a CUCM , just i need to know if this scenario applicable or not: is it possible to add a prefix to the outbound calls based on the extension number, example if the calling is 6623 and the called number (outbound call number) is 9912...
i have an issue, i have router 3825 i decided to make it as CME Router, Firmware uploaded and IP Phones are register normal. i have E1 card, dial peer Pots is configured but can't make outbound call. once i dial the first number i got a busy tone, ex...
i have IPSEC Site-To-Site VPN between Two sites, VPN is up and Private networks can reach Each Other. Site A "192.168.1.0/24" Site B" 172.16.10.0/24" lets say i need to limit BW usage for specific Host "192.168.20.20" to use maximum 2MB once he is tr...
I have a CME Router 2921 connected to SIP Router "Peer to Peer", which is giving me VOIP Service. i can make inbound calls normal and i can hear ringback tone when tested incoming calls from my Mobile or any landline Phone.
Issue is when i try to m...
Hello Everyone
I have setup B-ACD on my CME (all my Phones are SIP Phones ) and its working fine except one issue, when the the incoming call hit the Script i can hear welcome and Menu prompts.
Am using default Prompts Audio Files... here is the ...
calling number is my extension = 6623
Called Number is = 999109912 , the first "9" is a prefix
the debug for "debug voice ccapi inout" is showing the called number = 9 , i don't know why its sending only the first Digit only.
i tried to dial by...
