Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Mar 1 18:44:10 wlc.sup46 Cisco_ac: <mac>: *Dot1x_NW_MsgTask_0: Mar 01 17:44:05.667: %PEM-6-QVLAN_INTF_REMAP: pem_api.c:1836 Remapping interface ID for <mac> from 12 to 13 (ifname).
Mar 1 18:44:12 wlc.sup46 Cisco_ac: <mac>: *DHCP Socket Task: Mar 01...
I figured I'd post this as it has me confused. I have a a mix of 2800 and 2700 connected to a 2504 with software 8.3.104.131 (Beta). To my surprise I found an AP stating it's power level is 8. Is that even possible? The AP is a 2800 with the dual-ban...
I have an ASA5516X running 9.5(3) without a VPN configuration but a user pointed out to me that she needs to reconnect her Anyconnect VPN after computer sleeps when on a WLAN passing traffic through the aforementioned ASA while the problem isn't pre...
If I have a WLAN set to use an interface group with two interfaces and I have it setup without flexconnect functionality. All APs are set to flex connect. Some clients on the non-flexconnect WLAN end up on the VLANs (not in the interface group) that ...
I'm on a 2504 and had Global Multicast Mode set to on. This worked on all the controllers WLANs. On the guest WLAN I enabled P2P blocking but noted that the multicast was still active there. I tried to disable the Global Multicast Mode on the control...
As Leo stated it's pretty difficult to max out wave 1 and wave 2 ac but on a sidenote the AP3800 has a multigigabit port although in most deployments the main limitation, at least if you want to max out wave 2 is that there are only two 160 MHz chann...
I have implemented the following.
access-list outside_mpc_timeout extended permit tcp any any eq https
class-map anyconnectvpn match access-list outside_mpc_timeout
policy-map global_policy class inspection_default inspect dns preset_dns_map ins...
Hi Javier,
I was advised to notify you about this issue as it may be of interest to the development of the WLC software.
https://supportforums.cisco.com/discussion/13233986/nearest-aps-not-nearest
