David Hild

David Hild · 01-17-2022

Thanks for the prompt reply. The 10G side will connect to servers using 10G SFP slot. The included l...

David Hild · 01-17-2022

So I know these are compatible but I need to know if the port configuration for these cables is on a...

David Hild · 07-21-2021

Bumping for visibility and to add the Anyconnect version I installed was 4.10.01075.

David Hild · 07-19-2021

I installed the full Anyconnect installation on my new Zbook running Windows 10 a couple of weeks ag...

David Hild · 07-13-2018

Johnny,I searched for the WCCP feature set, then looked at WCCP v2 and found it is supported in NX-O...

David Hild · 07-12-2018

Johnny,According to the Cisco Feature Navigator Tool, NX-OS supports WCCP version 2. However, some W...

David Hild · 07-02-2018

CCW only allows you to choose one ESP. Your choices are ESP40, ESP100, and ESP200.I hope this is hel...

David Hild · 06-13-2018

This is a common question to which the answer is no. NX-OS does not have NAT feature capability. It ...

David Hild · 06-13-2018

No, the 6500 series line cards are not compatible with the 4500 series chassis.I hope this is helpfu...

David Hild · 06-11-2018

Any Ethernet interface can be administratively shutdown regardless of the connectivity status of tha...

David Hild · 05-30-2018

Here's the way I understand it:The Active (master) switch in a stack takes on the same role as a SUP...

David Hild · 04-25-2018

Hi Johnny.You can use the 40-Gigabit Ethernet Transceiver Modules Compatibility Matrix to see which ...

David Hild · 04-20-2018

Here is a general translation:Good morning, I have a Cisco ASA 5520 with the following interfaces co...

David Hild · 04-20-2018

Well played, t.svatek.

David Hild · 04-03-2018

Unfortunately this didn't answer my question. I'm asking if ISE 2.0 HLD is the latest because (stati...

Date Registered	‎04-26-2012 02:53 PM
Date Last Visited	‎05-16-2022 02:39 PM
Total Messages Posted	225
Total Helpful Votes Received	48

Re: C9500-12Q and 40G/10G Breakout Cables