Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,Router1(7200VXR) = IOS (tm) 7200 Software (C7200-JK9S-M), Version 12.2(13)T5, RELEASE SOFTWARE (fc1)Router2(3800) running 15.1 IOS I have already 2 HSRP Group and working configurations, but when I added this 3rd HSRP Group, it's not tur...
Check my blog: Check at the bottom part, it depends on the code you have. if it's pre 8.3 or post 8.3 ASA software versions. https://lewypogi.wordpress.com/ Kindly make sure your routing for the interesting traffic is correct so tunnel will be trigge...
Check my blog: Check at the bottom part, it depends on the code you have. if it's pre 8.3 or post 8.3 ASA software versions. https://lewypogi.wordpress.com/ Kindly make sure your routing for the interesting traffic is correct so tunnel will be trigge...
Hi Peter, I also want to accomplish this kind of setup but in my setup I want the SVIs from the Global Table to be leaked to the VRF CLIENT_A Routing Table... Is it also possible to this via dynamic routing protocols instead of static route? Here's m...
Hi Voice Experts, I have the same problem with John...Let's say I have also this kind of topology:Assuming: Coreswitch has the Switch-Virtual-Interfaces per VLAN...Cisco VoIP Phone -----(fa0/1)AccessSwitch(gi0/1)<===Dot1q===>(gi0/1)DistributionSwitch...
First of all, I appreciate you Glen and Richard for the quick response... I've already figured it out,I think my 7200VXR Router needs an upgrage because what happened is when I lowered the Standby Priority of my 7200VXR Router, it became the Standb...
