Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I’m deploying model 66 and 74 AP’s with two pairs of omni directional antennas. They will be mounted to a 35 to 40 feet ceiling in our warehouse. Are the antennas oriented to be parallel to the floor or perpendicular?
I have created a generic 'guest' wireless account credentials with a 26 week expiration time. This account is for the receptionist to hand out to visitors while at are facility. 1:) Can the same account be used by several guest at the same time? Or d...
I inherited a 3925 router that I don't believe has ever had a IOS update. It's on IOS c3900-universalk9-mz.SPA.150-1.M3.bin.
I'm wanting to update to IOS c3900-universalk9-mz.SPA.155-3.M2.bin.
Are their interim update needed to get to the version I w...
I'm in the process of establishing a new ASA VPN gateway (9.4.(1). All users are going to use the AnyConnect Secure Mobility Client 3.1.1 and two factor authentication. I have discovered that a VPN client can establish a VPN connection and can succe...
I have been tasked with establishing communications from my Cisco 4510 R+E core switch via a new fiber run (MM, OM3, 945ft) to Cisco 2960X switch. I'm using pairs of new Cisco SPF-10G-SR's on either end of the fiber. Before deploying the remote 2960...
I did a crude survey 6 years ago after we swapped the Nortels for Meraki. I used InSSIDer. I walked the floor with my laptop and an accurate floor plan. It showed rows and columns every 20 feet. I stood at the intersection and recorded the highest 2....
No survey done but an educated guess. We had Nortel AP's and purchased Meraki's to replace them. We put them in the same locations because of the cabling was there and the foot print of coverage had not changed. We recently have expanded the covera...
Thank you Andre for replying to my post. I have it resolved now. It was the physical layer. All that was needed was a pair reversal on one end of the fiber patch cable. I have had plenty of experience with ST fiber connections but was my first projec...
