Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good evening, I was wondering if it is time to add a new category under "Technology and Support" for CyberOps related topics.Alternatively, a new section under Security will be sufficient as well.I am preparing for "CyperOps Professional" and there a...
Hi all,I am bit confused in regards to what options we have in order to integrate Cisco Anyconnect/ASA with Azure.At the moment we are running on Office 365 & Azure with Basic AD.We are upgrading to "Azure AD Premium P1" but we don't have an on-prem...
Hello everyone,I would like to ask if there is a recommended interface configuration for supporting all methods of authentication in closed mode.
Also, in Closed-mode, i would like to know if an ACL is needed in order MAB to work properly.I am gettin...
Hello everyone,Assuming that we have 2 routers as EIGRP neighbors directly connected via the Gi0/0.
R1 is configured with a Loopback IP (192.168.1.1/24).
I would like to ask if there is a way to advertise two separate routes to R2:
1. one route for ...
Hello everybody,Assuming that you have 2 routers as EIGRP neighbors.Router 1 is configured with a Loopback IP (192.168.1.1/32).
I would like to ask if there is a way to advertise on R2 two separate routes, one /32 and one /24.
1. one route for 192.1...
Hi Marvin, Cisco Learning Network hasn't a forum section as far as I can tell.I appreciate that here at Cisco Community the forum is more support questions rather than learning. Nevertheless , since there is a dedicated certification track and produ...
@Leonterry , you only need one Azure AD identifier on the ASA config. The same "saml identity-provider" will be configured in every tunnel group that requires SAML authentication. This is regarding the App certificates:"If you would like to on board ...
We had to configure multiple Ent App because we have multiple locations and multiple Tunnel Groups.Since you have one tunnel group but 4 locations, I suppose you have to create 4 x Ent Apps .Because you need 4 uniquer pairs of Identifier (Entity ID) ...
@Leonterry , how many tunnel groups there are in each location?We have implemented this by using multiple Enterprise Applications (no load balancing to the nearest DC).One Enterprise Application per tunnel group. You can configure the Enterprise Appl...
@danielkuhl @danielkuhl , make sure that you are using the Cisco AnyConnect Client , NOT the Cisco AnyConnect App in Windows 10. I had the same issue, when the IT department installed the App and not the Client on new Windows 10 laptops.
