Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good morning everyone,i have to design a network topology in which convergence time should be around 50msec. This network should be a L2 Ring connected to an "server access network" through 2 L3 Switches.Currently i've designed two option:1) L2 Ring ...
HI Everyone,
i would like to do some factory acceptance test on the cisco 4430 and 4330 routers.
Where can i find the reference document with the procedure?
Which commands are generally used to carry out this tests?
Thanks a lot
Paolo
Hi everybody,
I know that default behaviour of Cisco is to create FECs based on the destination prefix known to a router (IGP prefix in the routing table).
Is there a specific command to show a list of FEC created on a router? i know only show mpls f...
Hi everybody,
i have the following problem (see the picture below):
The NMS Server need to know the Loop 1, 2, 3, 4 and 5 addresses in order to manage the routers associated with these addresses.
The routers associated with these addresses runs their...
Hi!
I have the following scenario: 3 blue routers are connected in Area 100 OSPF and the two edge router (the blue router on the left and the blue router on the right) have also one interface in Area 0 OSPF and are connected by a link in a VPLS. La...
Hi Richard,
thanks for your answer, you perfectly understood what the problem is.
The second solution you offered me is very interesting: you suggest me to create a second OSPF process (router ospf 2 - green OSPF) on R1 and R4 and establish an gree...
Hi!
Thanks for your answer,
i was also thinking about traffic black holing due to time of reconvergence of OSPF or OSPF-LDP time of synchronization.....i waited few second (2 or 3).
Tomorrow I will repeat the test waiting more and i let you know.
Th...
To resume:
Is this scenario, when SDH link fails is better:
1) That interface fa0/1 of Router 2 and Fa0/0 of Router 3 remains UP
2) That interface fa0/1 of Router 2 and Fa0/0 of Router 3 goes DOWN
I think it's better the Option 2 because prevents s...
