Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a dual stack IPV4/IPV6 router/firewall (C892FSP-K9).I configured IPV6. The thing is that IPV6 is not working as expected.The router is behind a French box (Free) giving Internet access. The symptom:No incoming traffic is going through the r...
Hi,I have set up filter for the inbound interface on the wan part.I permit www and 443 traffic from any to a specific host (2A01:XXXX:XXXX:C884:8000::1).I get the following error on the browser:<html><head><title>Service Unavailable</title></head> <b...
Hi I have a strange situation with my DHCP pool.
As you can see below, I made some reservation for the first 3 devices.
The thing I do not understand is that the devices get another IP address? Moreover, their Mac address is transfomed:
From 008e.713...
Hi,I need to link 2 sites together.My internet providers does not provide VPN passthrough (ESP) protocol or the possibility to put the modem or boxes in bridge mode. Look at the following discussion for more details. https://supportforums.cisco.com/d...
Hi, I have tryed to set up a tunnel between my 2 sites using GRE and IPSec technologies.It does not work. I would like to know where I am wrong???In the attached file, You will find all the details of the network with figures.
As some people will s...
Hi, Sorry for late reply.I found the solution, the problem came from the fact that I did not have default route ::/0.The ACL I had blocked automatic routing negotiation between the router and the box.Here is the ACL I had to apply to allow automatic ...
Hi ngkin2010,thanks for the help.I have to do like this: permit icmp FE80::/10 any nd-na
permit icmp FE80::/10 any nd-ns
permit icmp FF02::/16 any router-advertisement
permit icmp FE80::/10 FF02::/16 router-advertisemenIf I do not put the last lin...
Hi,I think I found the problem.When I remove the ipv6in ACL, I get from my box the default route to internet:ND ::/0 [2/0]
via FE80::XXXX:XXXX:XXXX:XXXX, GigabitEthernet9When I set the ACL, I loose the route.I must miss some command. I am not s...
Hi,From local network, it works perfectly well. In debug mode, Traefik gives me logs, the website shows itself in the browser.From Internet, I have no logs in Traefik???For me, No traffic goes to the service.This is wearied.Regardsvandman
