Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi allI'm confused with fusion router's concept. in our design, we put two C9500-12Q-A switches as the Fabric Borders with all 40G ports, So now it seems that all traffic that need to go out of the fabric will go through the Fusion Router, it mean w...
Hi AllWe have two N7700 and two N5600 switches.I tried to connect switches as below diagram with 40GBASE-CR4 QSFP Twinax Cables (QSFP-H40G-CU2M).N7K-1 ------ N7K-2| || |N5K-1 ------ N5K-2Now, th...
Hello and thanks in advance for reading our requestWe had a AS-5350 router which we used to connect Branches to HQ with dial-up, now we have it replaced with ISR-4431 router plus NIM-2CE1T1-PRI and PVDM4-64 modules for E1 connectivity.But now Branc...
Hi
We have upgraded our ASR9000 from ios-xr 5.3.4 to 6.2.3, but after the upgrade, ASR chassis does not detect 10G modules (A9K-8T-B) so we had to reload the chassis in order revert to the previous ios-xr version (5.3.4).
i got this log after upgrade...
@Remi Astruc wrote:Hi Scott,Unfortunately the answer is quite simple. QSFP-H40G-CU2M is not supported on the mentioned platforms, but only on C9400 as of today.Go for the 1M or 3M version. Remi AstrucDear Remi Astruc,Thanks for your kind attention. a...
Hi everybody , I have the same problem and I want to figure out my mounted modules are RF or not. let me explain more. our company purchased a 6500 chassis with mounted modules such as supervisor. the problem is I do not know the supervisor module i...
