Hello everyone
We are planning to replace for one of our customers the ASA 5520 firewall with the Firepower 2110.
The customer is using on the existing firewall (ASA5520) a CWS connector.
Will be possible to use on Firepower 2110 the same licenc...
Hello everyone
I would like to know what is the maximum local monitor sessions for the Cisco 3650 switches.
It is mentioned on Cisco Docu that it should be 8. Although on some other documentation
it's mentioned that it's 2.
It would be a great he...
Hello
For one of our customers, we would like to replace the existing ASA 5520 firewalls with the Firepower 2110.
The requirements for the new firewalls should be the following :
The new firewalls should be in HA (Active-Standby)
They will be a...
Hi everyoneI have an ME 4624 RGGW ONT which i want to test and connect it directly with a ME3400 Cisco Switch.Is able the router to support this connection (p2p) or is only capable for p2m(GPON) .As i see in its documentation it doesnt mention anywhe...
Hello
Thanks a lot for your feedback.
No I am not going to use the ASA OS on this device.
It will be a firepower 2110 appliance with FXOS and FTD on top of it.
So the question is if the Firepower can support CWS connector configuration the same way...
Hello
Thanks a lot for your feedback.
No I am not going to use the ASA OS on this device.
It will be a firepower 2110 appliance with FXOS and FTD on top of it.
So the question is if the Firepower can support CWS connector configuration the same way...
Thx again for the feedback. Although it's still not clear to me what is the maximum monitor sessions. Can someone in the community who operates the 3650 switches to verify how many monitor sessions are supported ?I have purchased the switch and I nee...
Hi Deepak
Here is the website :
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3650/software/release/3se/network_management/configuration_guide/b_nm_3se_3650_cg/b_nm_3se_3650_cg_chapter_0111.html#reference_A5581324604C43FDAB318320AC6...
Thanks Deepak for your prompt reply.
In the same documentation that you send me, if you read a little bit more down it's mentioned that the maximux
source monitor session is 2 (see below). So not sure if I am missing something here.
We would like...
