Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When I connect with my Cisco 2950 Switch, I can see the weird kind of language as per my attachment. Switch is working good with Cisco IP phones connected with it. Can anyone help ?
When I connect my Cisco IP Phone 7960 with 2950 Switch (any access port within voice vlan), I get the message on Port duplex mismatch but the phone works properly. From my switch the speed setting is 100/Full but from the Phone its Auto. My Question...
Hello Diana,
I had tried CCP 2.7 with ISR 4331 few months back but that doesn't seems to work well, it didn't gave me any options to configure Unified Communications.
Is there any particular version and setting required for CCP to work with ISR ...
Hello Gangabhavani, LDAP was working great with the IM&P & CUCM but the main issue was with URI Dialling. Unfortunately the information you provided me that Jabber to Jabber calls only supports in Version 11 via WebEx account is NOT correct. I have m...
Did you create the SIP Trunks for CUCM to talk with IM&P server ?You need to have special separate SIP trunk for this purpose and need to use the same trunk in the Publish in the Service parameters I believe.
Do you have E1.64 route pattern already in Place in UCM ?If not, create correct route pattern such as \+32[2-9]XXXXXXXXX as an example.Make sure not digit striping neither prefix should be use.I have created lots of E1.64 route patterns in UCM and th...
Yes, that is correct... Just one click call click..https://www.youtube.com/watch?v=-Py0jhEqe8E In the above video link, it is mentioned at around 1:03. So looking at our scenario where we have our own UCM and IM&P server, there is no way we can have...
