Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I have done IPSEC setup as below(Link) where one end ASA has public IP and the remote end is dynamic and ASA is behind a NAT.
Configure ASA-to-ASA Dynamic-to-Static IKEv1/IPsec - Cisco
Currently, the Hub CISCO ASA accepts IPSEC tunnel from a...
Hi All,
I have a situtation where i need to setup IPSEC tunnel between two CISCO ASA's. The main CISCO ASA only had public IP and remote ASA is behind a NAT device (Starlink). The remote ASA will initiate the IPSEC tunnel connection.
Fortinet does t...
Hi All, I have 2x3850 Stack switches and "FED" is taking up all CPU resource. Requesting if someone can help me find how can i find if this is a software bug and where in CISCO website can i confirm this. Below is CPU usage and version IOS i am using...
Hi All, Need you help. I am getting "unknown protocol drops" error in my CISCO C9300-48T switch and i think this is causing some application issues. Below is version and not sure if this is some sort of software bug. BOOTLDR: System Bootstrap, Versio...
Hi All, I have a 3 ANS e.g 100 200 300 when advertised to the internet 100 200 300 ASN path is shown, i would like to overwrite the ASN and remove 100. So ASN path to the internet will only be 200 300. I used "as-override" command under address famil...
Thanky ou Aref.. the first link was perfect and was able to do this. Currently the config is accepting IPSEC connection from all public IP range but i would like to lock this down to a specific public IP range. Are you also able to tell me how this ...
