Areyouserious
Level 2
Level 2
Member since ‎05-23-2014
‎05-06-2022
Awards
No awards available to display

User Statistics

  • 49 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 5 Helpful votes Received
Recent Badges
Certifications
No certifications available to display

User Activity

Hi All,I've been trying to figure out how to enable incoming calls on CME with a sip trunk.  Our CME is behind another border edge router, hence the ip route command in my config. I'd like to have our DID number ring a group of our phones, but Can't ...
Hi all.   Had some very strange issues this evening.   I have a 2960 Switch that only seems to like certain devices being plugged into it.   For example, I tried plugging two different laptops into a few different ports, namely port 4, 5, 6,  but no ...
Hi everybody.   I have a Cisco 2811 router with one Fastethernet L3 port in trunk mode, with sub interfaces, and a switch connected at the end with Vlans set up in another room.     I had planned to use the gigabit port on a NM-ESW-16 module to creat...
    Hi all.   I have a cisco 2811 behind a bridged broadband modem. The link is configured on one of the router ports is DHCP.   I have an ACL on this port that denies all traffic coming inbound, as well as CBAC enabled to inspect traffic going outbo...
We have two Cisco 2811 routers on two sites, with a an IP SEC GRE tunnel linking each site.   On each end we have a broadband modem in bridge mode connected to each 2811.   Each modem connected to interface fa0/0, with DHCP  and NAT set in place.   T...
Community Statistics
Member Since ‎05-23-2014 12:17 AM
Date Last Visited ‎05-06-2022 12:04 AM
Posts 49
Total Helpful Votes Received 5
Helpful Votes From