Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, all
I've recently installed PI 3.3 and configured it (as much as possible) according to Admin and User Guide. However I am facing with a strange Job Scheduler issue - some job is keep failing and giving me this error:
However under Ad...
Hello, allI have a question regarding bandwidth requirements for Cisco IP Phones to register on CUCM using SCCP protocol. I was able to find a document, which clearly describes network interfaces for CUCM - http://www.cisco.com/c/en/us/td/docs/voice_...
Hello,
OK, based on your configuration you are using PVST mode. Make sure that your Fortinet switch is using the same STP mode otherwise you may face up with very strange LAN behavior including Layer 2 loops. Second - due to you are not specifying ...
Stack feature is a model-based, not software-based. Theoretically it should be possible, however I do not quite understand why. Ideally your stack needs to run same software version to avoid odd functionality.
More information you could find here:...
Hello,
Load-balancing method is a matter of IOS features and ether-channel configuration. More details could be found here:
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3750x_3560x/software/release/12-2_55_se/configuration/guide/375...
Hello,
Couple of questions / considerations:
1. Is there any possibility to see Cisco 2900 switch configuration?
2. It could be a good idea to use native VLANs on trunks as well
3. Consider to disable DTP on trunk links at least between Cisco 290...
Hello,
By default packets will be processed, so clients in VLAN 10 on both switches will remain connectivity. However depending on Fa0/0 ports configuration on both ends, this "access-trunk" link may not be formed at all and / or might be blocked. ...
