Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone I am having a problem with the following scenario.I have a small server at home. I have configured the NAT and I can connect to the server from the WAN. There are two special ports which I need to connect to from outside and the server ne...
I need to allow a customer to start, stop and show ip accounting but I cant give him full privilege access to the configuration mode. I am thinking of creating a menu for this but I don't know if this will allow me to run commands in the config mode....
Hi I have a new ASA 5505I have place it after the service provides cable modem.I have created 2 vlans. Interface e0/0 is part of the vlan 2.Vlan 2 has an ip address of 192.168.0.2 255.255.255.0The name is outside so by default the security level is 0...
I am building a home lab. I have a Cisco 871 router connected to the ISP router. I need to configure this router so that it forwards the traffic back and forth between the LAN and the WAN. This router has one want interface and four switch ports. c...
I am building a home lab. I have a 1841 router connected to the ISP router and is configured and works good. I have 3550 switch inside my network. I can ping as far as the outside interface on the router, but not further then that. No idea why. I hav...
Hi Milos
I am trying to do this for a customer who don't have much exposure to Cisco command line.
I can give him access level other the 15 however i still have to show him other commands.
I would like to have a solution which is easy. He would li...
I am sorry I had to time to log in here and update my post. Tha problem was my routers memory. I update the IOS and everything is good now. Thank you Santosh
