Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We're planning to implement BYOD in our wireless network but have several issues during pilot testing. Specifically we were testing client device behaviour, which already had successfully issued user's certificate, after changing EAP certificate (in ...
Hi!Maybe that was discussed before but I failed to find anything similar to our task. Anyway, we have several guest/temp workplaces equipped with PCs and a cisco phones so different people can come and log into the PC, Cisco ISE would assign some ACL...
Hi!
I'm trying to boost my EEM on Nexus 7009 switch by making it possible to send emails using python. I have a python script that sends emails without any problems if I run it manually but when I try to run it via EEM applet I get an error message:
...
I'm trying to figure out how to keep my guest clients connected and authenticated when they roam between aps. Once they move to another ap, web-auth page would pop up and they have to put their credentials again. Is there a way to fix that?
Hi,I have some problem with CMX dashboard configuration, I followed the configuration guide (http://www.cisco.com/c/en/us/td/docs/wireless/mse/7-6/CMX_Dashboard/Guide/Cisco_CMX_Dashboard_Config_Guide.html) and can't understand, how do I add a map to ...
You're right as long as the new EAP cert issued by the same subCA and Root CA we have no issues, but at some point in the future those certs are gonna be reissued too (subCA and Root CA), thats where we begin to have a problem: ISE doesn't allow to h...
Thank you so much!
Apparently Nexus switch runs eem commands using some system user "svc-isan", so I just created a new user with the same name on our ISE server and gave it admin privileges and it worked! Now I'm able to receive emails generated b...
I did a site survey, the problem happens only when clients roam to another ap, apparently, their session resets every time they move from one ap to another one. I believe there should be some piece of configuration that would keep their session on ev...
I also noticed when I try to configure Connect and Engage Service in Cisco MSE i get this error on Prime:Permission Denied You do not have enough permissions to perform this operation.
I checked CSCul58730 bug, but there is no information about my problem, it's about tracking clients, i don't have any problems with that, MSE tracks clients perfectly well and shows them on maps in Prime
