Hi All, I am using a ACS 5.5, i can manage the Appliance using WEB-GUI. Now i am planning to upgrade the firmware. Did any one knows how to enable SSH service on WEB-GUI console.
Hi i have one remote site, i am unable to ping my remote site firewall from my current location packet is dropped at router any one help me to solve this?
Thanks Jon I have tried that, i am unable to get into CLI using my GUI password. Can you share me the procedure to configure user name & password for CLI please.
I have MPLS connection, service provider also advertise my lan segment ip in their router. my exact issue is i am able to reach remote site lan segment except firewall. when i put a tracert from my system means packet is dropped at the router, but i ...
what is my exact issue is i am able to reach my remote site local network except Firewall, when i put a traceroute to remote site firewall means packet is dropped at router.
Hi thanks, here i shared my requirement plz help mei have only one vlan want to configure two ssid one is user and other is guest both are in open or password protected
I tried it yesterday but no response, no also tried too still the same will happen ARDAL-AP01(config-if)#do sh int d0Dot11Radio0 is reset, line protocol is down Hardware is 802.11G Radio, address is 003a.9afa.1380 (bia 003a.9afa.1380) MTU 1500 byte...
