Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!I have a customer being told by a competitor WiFi manufacturer that there is an AP limit with Meraki. There are customers with 10s of thousands of active APs, and so I was wondering if there is perhaps a limit of APs within particular Meraki "...
Hello!
We are preparing to implement a new DMVPN/PfR WAN for a customer, in preparation for their roll-out of VoIP.
For the best VoIP support, of course we would prefer to allow voice traffic to flow directly spoke-to-spoke. However, the custom...
Hello!
We are preparing to install a 2110 FTD 6.2.2 High Availability pair (managed by an FPMC).
1. Is it possible to use a wildcard certificate?
2. If not, is it possible to use SANs? Each FTD has to have its own unique name, such as ftd1.<dom...
Hello! I thought I remembered seeing or reading release info that the recent version(s) of AnyConnect now provide built-in Anti-Virus capabilities. However, I don't see anything about that in the data sheet. Is this the case, or not?Thank you!Deb
Hello!
Is it possible within ISE 2.1 to limit profiling to certain SSIDs only? (Specifically, the request is to disable it on a Guest SSID, while leaving it enabled on all others.)
Thank you,
Deb
That sounds like an interesting possibility, Mohammed!
Thank you for the suggestion.
Might you have a known good sample config that you could share or direct me to online somewhere? (If not, never mind....just always prefer to save time by sta...
Hi, Marvin. Thanks for the reply.
We need the certs for identity only (no SSL/TLS decryption). We are going to run two x 2110s in HA, managed by an FPMC.
Each FTD has to have its own unique name, such as ftd1.<domain name>.com, and ftd2.<domai...
Hi, Marvin.
Thanks for taking the time to respond.
I have also opened an SR with TAC, and if there's any different news from there I'll post it here.
Regards,
Deb
