Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm creating a qos policy-map on cisco 3650 (ws-c3650-24ts, IOS-XE Software, Catalyst L3 Switch Software CAT3K_CAA-UNIVERSALK9-M, Version 03.07.05.E RELEASE SOFTWARE fc1) - License Level: Ipservices the command i used is: ip access-list extended VPN_...
Hi, I'm a newbie and currently learning to configure MPLS. I can't find a good explanation why I would use MPLS on my topology. I know there are lots of articles in the internet explaining about what is MPLS & how it works & how to configure it, but ...
Dear all,I tried to setup an equal cost load balancing with OSPF (yes I know with EIGRP it can be easier but my environment uses multi vendor setup therefore EIGRP can't be used) but it doesn't seem to work. So let's say my Cisco router (R1) connecte...
I have a Cisco 3650 with IOS XE version 03.07.03E and unable to implement flow monitor on a L3 port-channel. Please advise how can I get this flow configuration to work in Port-Channel interface.
Response that I got:
Sw3650-01(config-if)#ip flow mo...
Is ACL deny statement supported for WCCP redirect-list configuration in Cisco 3650?
Model: WS-C3650-24TS
SW Version: 03.07.04.E
License : IPservices
here's part of my configuration to make it clear:
!
ip wccp 0 redirect-list 126 group-list 10 pass...
yeah, on the front page of almost all search engines that i tried, the article related to mpls always making the perception of bgp redist as prereq for the implementation of mpls... and that's where my misconception comes from happy that i found th...
Hi Jon, this is the kind of answer I need! Why didn't I tried this before - I removed the redist BGP command on OSPF and things are working without P router needs to know the information of customer network on its routing table!Thanks!!! now i can sl...
I think what @fdharmawan wants here is to authenticate desktop using dot1x but authenticate the ip phone using mab.And from what i understand, some desktop are connected to the switch with the ip phone inline...please confirm if this correct that asi...
Hi Meheretab, thanks for coming by... here's the output as requested: R1#sh ip route ospfCodes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external ...
