Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We, have a new 3850 stack with four switches. At first, the stackpower was set to redundant, so we were only getting about 200-ish wattage per switch. We set it to power-sharing and now have about 400+ on some switches. However, as you can see switch...
The sync.log and sync.dbg are showing the following errors. We noticed the resources modified in UCCX GUI, do not sync over to WFO - monitoring and recording administration. Attempting to manually use the synchronize database, provides a QMAD2003 err...
We had a bad WAAS module at one of our locations. I built a quick test lab at our corporate office with similar hardware (2821,3560). I've enabled ftp via 'inetd enable ftp' on the WAAS module on the test router (2821).The host computer I'm connected...
We have two UCCX servers, UCCX01 and UCCX02 for example. UCCX02 seems to stay up constantly without issues. However UCCX01 randomly (monthly) and now weekly will not load the web GUI. The other fix is to reboot the server during off hours. Is there a...
We have a similar setup with a 5508 WLC and around 50 3502 access points on 8.0.120
The issue occurred only at one location (I have other locations with similar configurations) when I turned off Guest Wireless WLAN. This caused the WPA + WPA2 based ...
Solution. I wr er the WAAS module and then reconfigured, including the FTP command. Then I uploaded the WAAS firmware and installed the new firmware collowing Cisco's best practices. Neither Cisco TAC or the forums could really help, so if anyone els...
Thanks guys, worked. My issue was that after using the help feature "?" after utils service restart "?", it just said serv. There wasn't a list of options. But obviously just doing Cisco Tomcat I was good. Thanks again.
