Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, EveryoneHas anyone seen this log into the Cisco ASR 901 router:pstorm_bcm_prog_tunnel_push_1:2032: MPLS Tunnel index crossed maximum limit. l3intf=740, Err: -6, Label= 306. primary pathBest regards
Hello guys,
I have the following configuration syntax on my IOS-XE (ASR1001) device:
!...!aaa authentication login default group local AUTH1aaa authentication enable default group AUTH1 noneaaa authorization consoleaaa authorization config-commandsaa...
Hello guys,
I am facing a new challenge, I have two interconnected equipments in which it is not possible to have remote access being inside one of them to the other via the SSH v2 protocol.
When I try to access from CRS-1 (IOS-XR) to ASR1k (IOS-XE) ...
Good morning, Carissimos,
I need your support, recently I noticed that when I try to execute the "ping" or "traceroute" commands to a peer-to-peer IP address with or without source, I get this message "% Invalid destination ipaddress" as below:
R...
Bom dia Carissimos,
Preciso de um suporte vosso, recentemente constatei que quando tento executar os comandos, "ping" ou "traceroute" para um endereço IP ponto a ponto com ou sem source apresenta-me esta mensagem "% Invalid destination ipaddress" c...
Hi balaji
When I put the instruction below as suggested:
aaa authentication login default group tacacs + local,
you no longer have user access with both local user and domain user associated with ACS Server.
Example:
RT_IOS-XE(config)#aaa authe...
Good Sam,
Thanks for the feedback, also open a TAC, and they also suggested the same, as it is a production equipment and loads many services, we are preparing an action plan to perform the suggested action so as to avoid the minimum of possible dowt...
