Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello forum team, we are planning to migrate 913x APs to 916x APs to follow new WPA3 standard and wifi 6, however I do not see option for external athena in new 916x APs. Do You know if this is supported?
hello forum Guys, I would like to discover eigrp neighbor AS system nr to configure eigrp in between 2 routers - is there any debug command I can use to achieve this? I have: top: R1----------R2 R1#sh ip int br
Interface IP-Address OK? Method Sta...
Hello guys,
I have 2xC3850 stadck switches. Now they are working as standalone switches, both in active state when you issue sh switch command:
sh switchSwitch/Stack Mac Address : 9c57.ad9f.4300 - Local Mac AddressMac persistency wait time: Indef...
Hello forum guys,
I have three switches in LAN network which run in rapid-pvst mode. I would like migrate to mst.
I try to search cisco documentation and I found that migration from 802.1D to 802.1w is cousing outage:
http://www.cisco.com/c/en/us...
Hello guys,
I have an issue two C3850 switches. One of C3850 is in the production and operates normally - second one I am adding to the production. Previously those switches were stacked - however I DO NOT want them to stuck. I want them to operate ...
I created packet capture however it does not show anything: access-list 100 permit ip any any
monitor capture buffer CAP-BUF size 2048 max-size 1518 linear
monitor capture buffer CAP-BUF filter access-list 100
monitor capture point ip cef CAP-POINT ...
this is config for R2: router eigrp ???
net 38.1.1.8 0.0.0.0btw - network statement was discovered from multicast ping. we need to find out what is AS of eigrp without looking at R2 - we do not have access to R2. if interface on R2 was passive, we w...
debug eigrp neighbor does not show anything... packet capture yes, but assume that I have only routers to play with. when I configure: router eigrp 2
network 38.1.1.3 0.0.0.0then I get: R1#debug eigrp packets all
*Nov 20 08:37:54.647: EIGRP: Sen...
hi
I have done similar config but I can not reach vrf sites between PE routers:
PE2:
PE2#sh run | s bgprouter bgp 65006 bgp log-neighbor-changes neighbor 172.56.17.7 remote-as 65006 ! address-family vpnv4 neighbor 172.56.17.7 activate neighbor 1...
