Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My recent encounters of PTP have caused to question my understanding of clocks. My understanding of the topic is that the frequency fed through SyncE/10M connection will allow the DUT to synchronise its oscillators with the master allowing it to main...
I was recently using an online website for checking the name resolution for a particular website.
The result was as attached in the picture . As is visible, www.cisco.com resolves to e144.dscb.akamaiedge.net to a public address. How does a domain na...
Hi Guys,
I am using WS-C3650-24PD-S for a customer deployment and I can see 4 uplink ports on the switch . The datasheet marks them as 2 Tengig and 2 Gig or 4xGig ports. Can I use all the 4 ports as 4 gig ports ? Does this require any extra command ...
Hi Guiseppe,
I honestly thought OP meant control plane updates. Since we don't have a direct EIGRP neighborship between the two CEs, the updates wouldn't have to traverse the MPLS(Not as an EIGRP packet)
Thanks for the clarification !
Hi ,
These two processes seem to be the culprits :
56 153874756 680837438 226 2.61% 2.65% 2.69% 0 Cat4k Mgmt HiPri57 363174821047547247 34 95.64% 95.42% 95.32% 0 Cat4k Mgmt LoPri
We would need the output of "sh plat health"
This seems to be a fair...
Hi ,
1. If both the customer sites have the same AS, then the EIGRP attributes embedded in the BGP updates are used for calculating the metric and there is no need for a default-metric or the need for mentioning the metric while redistributing the ...
Hi Rolf,
Point noted. The route is indeed the internal discard route which would be seen as a summary on R3 and R4. I somehow seemed to have missed that in the output !
Surya
Hi ,
66 seems to be the switch IP. However, you will be accepting option 43 set packets from the APs. So the hex value is calculated for the range of AP IPs. The process to do that is mentioned in the document attached above.
If that does not help ...
