Hi All,
When we try to configure syslog source interface with loopback or Vlan we are getting following error.
Router(config)#logging source-interface vlan 281Interface Vlan281 is not in the global table
But if Vlan or Loopback is not a membor any...
Hi all,If i give ISP's DNS when both isp's up , Internet working for end user.But if one isp goes down , that isp's dns configured machine unable to access internet. but if i give 4.2.2.2 or 8.8.8.8 it is working. How to solve this issue..? I have Co...
Hi All,I have a two different ISP s configured BGP with Core Router. I have to set path for some ibgp sessons goes through isp1 and remainig ibgp sessions goes through isp2 and If one isp down means another isp have to take over all ibgp sessions.I ...
Hi Chris, Thanks for reply. I checked with ISP side , for some security reasons they are not allowing other ISP's inside with their ISP. Thanks.,Prakalathan.K
Hi Chris, Thanks to reply.the problem is, 1)DNS server of BSNL was reachable, if ISP BSNL is down 2)client with BSNL dns server cannot go online even though BSNL dns server was reachable from client however BSNL ISP was down same issue with Vodafone...
Hi Marshall,Thanks to relpy.I'm trying to achieve both incoming and outgoing traffic of client 1 &2 through ISP1 and Client 3&4 through ISP2 .If ISP1 fails, ISP2 take care all clients in network.IBGP sessions among core and client routers and EBGP be...
Hi Milan,Thanks to reply. i added iBGP sesssion between R5 and R3 its working fine.How to configure define paths in R3 for R1 to reach R5 via R1>R3>R5 and R2 reach R5 Via R2>R3>R6>R5. and if link between R3 and R6 down means , R2 has to take availabl...
