Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have been asked to configure QoS on our router for voice traffic. The link is 1GB and the request is for 4.8Mb EF and 200kb AF31 traffice to be configured.
I have only ever had to configure traffic for one dscp before, setting up an ACL with ...
Hi,
We are receiving Ironport Spam Quarantine Notification emails from an ironport email address (ironport@domainname) and need to change this but cannot find where it is getting this email address from?
I have checked the System Administration -> Re...
Hi,
Apologies if this is posted in the wrong community.
We have a NAC manager and 2 CAS where the external CA SSL certificates are expiring on 1st November. These are certs based on the internal IP addresses of the applainces.
Due to a change in the ...
Hi,We are currently running Cisco Unified CM 9.1.2.11900-12.We have had a user call in stating that they are receiving a number of calls asking for other users and she has contacted us asking if we can trace if any user has forwarded their phone to h...
Hi,We have a C210 M2 server using an LSA MegaRAID SAS 9261-8i storage adapter, which hosts 10 HDDs - all of which are 140GB. One of the HDDs have failed and our support company have said that the 140GB HDDs are no longer available, and have sent a 30...
OK I have done some more research and have seen that you cannot add two output service policies onto 1 interface, so changed my config to the following:
policy-map SIP_Trunkclass Voice_EF bandwidth 4800 fair-queueclass Voice_AF31 bandwidth 200 fair-...
Aaron you are a star! This has got me exactly what I need and will be very useful in future queries, I am sure!Thank you so much for your quick responses in helping me resolve this issue!
Hi,Thanks for this Aaron - but this only brought up 2 users with calls being forwarded (more call forward when busy, etc.) where I know we should have a lot more users than this?Is there a way to query just 1 target DN?Thanks again
