Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello! I have to Cisco ASA 5515 in Active/Standby mode.
Can in install Firepower module only in Active ASA?
Can i move SFR from Active to Standby if Active fails?
Thx in advance!
Hello ! We have a wireless network in office, 8 APs 1602I and virtual WLC (8.0.115.0). We do not have a lot of wifi users (about 20 around the office) and wireless network works fine. Sometimes, but infrequently, one of a wilreless client may randoml...
Hi all !
I'm looking for help with a strange problem with NAT and RACL. I have a router Cisco 2951 15.5(3)M IOS with LAN and WAN interfaces.
There is one inbound ACL "INTERNET" on LAN inteface with rules that permit and deny some traffic from local n...
Hello ! I'm looking for advice in this matter. We have one virtual WLC with base-ap-count license for 40 APs (we bought L-LIC-CTVM-UPG and 7 x L-LIC-CTVM-5A), but we are using only 18 APs.We are going to buy another one WLC for remote office and want...
Hi !I'm looking for help with a problem. I have Cisco ASA Virtual Appliance version 9.3.1 with WAN, Internal and DMZ interfaces.Internal network works well if nat to WAN-interface ip address (for example, nat (Internal,WAN) source dynamic interface (...
Hi, Rahul. Thx for your answer.
The SFR is not installed on a separate hardware module slot as the ASA5585, but SFR is installed on separate SSD disk. So can i remove SSD and insert it to another ASA?
It can be useful when i want to replace my old Ci...
Hello, Jeet! Thanks for this document.
I try to configure Cisco ASA VPN with native Windows client but it's not working. I receive "Error 720 - A connection to the remote computer could not be established"
I think there are no problems with crypto, h...
