Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The release notes specify that you must break your HA pair before upgading, but I am not aware of a recommended procedure to do that. I am also looking to find experiences from anybody who has upgraded and has any insights good or bad in relation to ...
It is my understanding that prime infrastructure 1.2 was supposed to be the first release towards merging LMS and NCS into on application. I have upgraded my install of prime ncs to prime infrastructure 1.2 and everything is working OK, but I am sift...
Looking to design for redundancy and mobility. My initial plan was to use LAG on both but I am confused on the setup because typcially all interfaces on these two switches are setup with HSRP. Does anybody have a matching configuration example they c...
When is Cisco going to bring the WLC upgrade process up to par with other products like the ASA or ACE where you can upgrade one device at a time? 0 down time is what management is asking for these days.
If there is a road map for this please let me...
I just opened a case on this. Our reports are actually working for switches I believe just not firewalls. I have confirmed that we had a change yesterday on a firewall it was picked up by the system as a change. Run a 24 hour change report and its sa...
https://supportforums.cisco.com/discussion/12213516/prime-lms-42-and-sync-archive-ace-modules-ace10-ace20 Karoly try the fix from this support article where Jason illustrates how to fix another issue that may be related. It seems that over ssh we cou...
