Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello I have On site a cluster of WLC 5508+HAand it works with iOS 8.5.161now I have another new cluster of WLC 3504+HA of iOS 8.10 and need to do mobility group between both clustersI read that we can do mobility group of different IOS but will have...
Hello Colleagues ,I have a cable QSFP-4X10G-AOC10M that i need to connect the 40G port to 3850-48xs and use 2 of the 10G ends , 1x10G to be connected to 3850-24xs and 1X10G to a controller 5520? datasheet stated that These breakout cables connect to ...
Hello , I have 2 WLC 3504 and need to connect the Redundancy ports -> I checked the deployment guide and found that they should connect back to back or via L2 switch , the question can I use L3 switch instead of L2 switch ? thanks
ThanksSo do I need special commands to split the 40G port to four 10G ?Another question: this cable has it’s SFPs already attached or should I order SFPs for this cable?Thanks in advance
thanks for your reply , yes , I checked that controller support this cable , my question more related to the configartion for the cable .as from the 40G interface , how i shall configure two different 10G interfaces with different configrations .@R...
