Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All
Although i have seen a similar question asked it did not completely align with my use case so apologies if it sounds the same.
I have a deployment where a number of IDS rule are being triggered and dropped by inbound traffic to on prem webser...
Hi Has anyone had an issue with Microsoft Surface docking stations where they stop responding midway through the eap negotiation. It starts okay and I can see from both the ISE logs and a capture of the EAP session that the Microsoft Surface docking...
I Have an issue where 'normal' domain devices are authenticating correctly to ISE however Windows devices that have also been configured for always on fail to correctly authenticate From the logs below you can see that it get very close but fail...
HI Everyone I have a fleet of ASR920 and a few (very few) interfaces are reporting transmit discards and I'm suspecting micro bursts as the root cause however the reported avg traffic flow still feels a little low for the risk of micro bursts. Any h...
Hi All Just implementing an ISE solution to a new network that has a legacy wifi network and clients are not able to roam from an authenticated port on a switch to an Authenticated port on a down-stream switch; as the upstream switch still thinks th...
Hi Thomas I have made a little progress forward on this issue It seems that the customer had set the Windows supplicant to use the computer's name/Password and not the certificate as was in the HLD - I suspect that the PC was not allowed to pass th...
HI Thanks for your comments i don't have a screen shot of ISE to hand - but it essentially reports that the client stopped responding which aligns with the pcap image attached. Unfortunately we can not bypass the docking stations as without it ther...
Thanks for your comment The always on solution id the built in Windows solution and not AnyConnect so we are currently researching how this operates - the working thesis is that Windows (as the ISE log suggests) just stops responding thoughts? Andy...
Thanks for the suggestion - I had found something similar after creating the thread for Layer 2 service and assumed that I could do something similar for a layer 3 interface Andy
Thanks for your comments and this is clearly the situation - but im surprised that there is not a fix for the issue. I'm sure I'm not the first to have had it. Andy
