Introduction This script was written to gather the current software version, SRU version, and VDB version from remote Sensors. get_sensor_sw_versions.pl To execute the script, first copy the script onto the Defense Center. The script can be run from any directory, but for convention /var/common, /var/tmp, and /Volume/home/admin, are most often used. The following example uses /Volume/home/admin: admin@dc:~$ ls get_sensor_sw_versions.pl Then, elevate privileges with "sudo -i" to allow the script to run all the commands it needs to operate properly and change back to the directory where the script was copied: admin@dc:~$ sudo -i Password: root@dc:~# cd /Volume/home/admin/ root@dc:/Volume/home/admin# ls get_sensor_sw_versions.pl Then run the script: root@dc:/Volume/home/admin# perl get_sensor_sw_versions.pl The output file will be placed into /var/common with the following format:  hostname_version_info.csv Please contact me for any enhancement requests. Output: This script collects current software/VDB/SRU versions to CSV file in /var/common/: Warning: Using a password on the command line interface can be insecure. File created: /var/common/dc_version_info.csv Sample output: root@dc:/var/common# cat dc_version_info.csv DEVICE, IP, MODEL, SN, SWVERSION, SRU, VDB 543dSensor, 169.254.11.22, Virtual Device 64bit, None, 5.4.0.7, 2016-07-25-001-vrt, 271 Compatibility Information: Version Verified Additional Information 5.4 6.0 6.0.1 6.1 6.2 Platform Verified Additional Information SFR module 3D sensor FMC FTD FX-OS Not tested against this platform yet. ... View more