I am working on a scenario where I have Cisco IE3400 Series Switch with Network Advantage License. Our client requirement is to have 2 x Uplinks one is directly connected over fiber with a remote switch (to be configured as L3 using EIGRP) and other ...
I have a scenario, where client has requested for MPLS - TE FRR and RPVST Support in access switches. We have recommended C9300 at access level along with C9400 + ASR at core.
My understanding is that ASR will take care of all the MPLS related thi...
I am working on a scenario. where requirement is to have a RING Topology between the distribution Switches. we have total 3 pairs of Distribution Switches and they will be configured as VSS.
In this Scenario is it possible to have a RING topology?...
I have an Scenario, where I am using Cisco 6901 as Hotline Phone and Third Party SIP phones as well. I am using Cisco Call manager Express. I want to know that whether I can configure PLAR with Cisco CME?
Hi Everyone,
Currently, I am working on a project where I have 2 Cisco 4507 acting as Active and Standby. HSRP is configured among them.
I am observing High CPU Utilization on the Standby Core Switch as well as on the Active. But on the Standby i...
Its not configured yet. Still in design phase. Customer Requirement is to L3 routing protocol to be used via FO and Microwave Link. I have attached here the Setup for your reference to have better understanding. What are your recommendations does th...
HI Rasmus, Thank you for your response. Actually first link from ICT Switch L3 Link will be over Fiber Optic Cable and Other Link is connected to a aggregate switch which is connected to a DMR device. requirement is to have FO link as primary and Mic...
Dear Nipun,We are in the procurement stage as of now. We have decided initially to go with CME. But we have some 3rd party phones that supports SIP. We have to use those phones because of the industrial area.Other option is we can go with CUCM i was ...
Dear Nipur,
If i go with CUCM instead of CME, will my requirement be fulfilled?
I am looking for a solution where if one phone goes Off-hook, it should dial a Pre-Configured Extension?
Regards,
NA