Ok. I have been racking my brain out on this with no luck. Could really use some help in fixing itSo here is my issue. I have 2 different VPNs and both are able to be connect to. I have split tunneling enabled and that works. But when I am connect to...
Good morning everyone. I am in need of some help. I am a newbie when it comes to configuring the ASA. Here is my problem. I have the asa configure and it is allowing me to get out to the internet. I have several VLANs on my network and from inside I ...
ok, I have picked up a second hand 2801. I was in the process of doing a WR after a password recovery when my power fluxed just enough to mess up the router. Now when I try to boot up it will decompress the bin from the CF and then I get an error mes...
Ok Thanks for you reply David. I made the changes you suggested and which I also posted below for reference. With this change I was able to access the shares through the VPN but now it seems to have broke my Split tunneling. Any ideas how how to fix ...
To answer your questions, No the router is not booting the wrong image. I have personally downloaded it from Cisco. I have also formatted the CF card. The little bit of research I have been able to find say that the cookie is corrupt. But I have no c...
Here is a what I get when I power up the router. System Bootstrap, Version 12.3(8r)T9, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) 2004 by cisco Systems, Inc.PLD version 0x10GIO ASIC version 0x127c2801 proce...
ok sorry that it has taken so long to reply. Busy with school. I have ejected the wic card and still stuck in a boot loop. Same error message as before.
