Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I'm struggling to access some web servers from client VPN. I suspect that there is asymmetric routing since VPN device and web servers are in the same VLAN on the switch and in the same security zone on the firewall. Please see the below ...
Dear all, Could you please advise me client isolation examples in catalyst switch?Can I achieve it with vlan access map for example first 50 IPs are servers and rest are client machines?Maybe better ways? Please advise me some examples. Thank you.Is...
Hello all, I like to see who or what is using most of the bandwidth (top consumers). My setup is like below. Cisco C3750 switch is connected to juniper srx cluster. Every connection is shared by firewalls via cisco switch. I like to monitor the bandw...
Hello all,We have third party firewall cluster. We are configuring Azure Express route in our infrastructure. On Microsoft side, there are 2 vlans for Microsoft peering and one for private peering. They also have primary and secondary connection for...
Hello all,We have data vlan and voice vlan. All the ports are configured with " switch port access vlan 10" and switchport voice vlan 20" commands.Our problem is when provider changes some settings on auto-provision file, CDP and LLDP are disabled an...
Hello @thetrainerx I know this post is old but I'm also trying to configure VPN between Juniper and Cisco with BGP. Could you please share example config for Juniper VPN with BGP. Thank you.Isac
I've read them but they are too general. What I need is in 192.168.33.0/24 subnet, allow access to server IPs 192.168.33.1-70 and block rest (192.168.33.71-255) to talk each other in VLAN33. Of course it would be great to allow access to fileserver ...
