cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
615
Views
0
Helpful
1
Replies

C40: Display local PC content at no connection with 2nd screen

Juergen Hornung
Level 1
Level 1

The PC is connected to the C40 (TC7.1) as source for presentation. Is there a way to automatically display content of this PC when far end side transfers no content?

(With other words, screen should display PC content always except far end side transfers content) 

1 Accepted Solution

Accepted Solutions

Patrick Sparkman
VIP Alumni
VIP Alumni

Hello Juergen -

It's not possible that I know of to automatically send the presentation source without some user interaction via the remote or touch panel to send it to the far-site.  You can however, configure the presentation input to automatically display on the screen when it's connected to the codec, then all you have to do is, send it to the far-site.

See the profile-c60-c40-and-codec-c60-c40-administrator-guide-tc72, pg 120.

Video Input Source [1..3] PresentationSelection

View solution in original post

1 Reply 1

Patrick Sparkman
VIP Alumni
VIP Alumni

Hello Juergen -

It's not possible that I know of to automatically send the presentation source without some user interaction via the remote or touch panel to send it to the far-site.  You can however, configure the presentation input to automatically display on the screen when it's connected to the codec, then all you have to do is, send it to the far-site.

See the profile-c60-c40-and-codec-c60-c40-administrator-guide-tc72, pg 120.

Video Input Source [1..3] PresentationSelection

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: