Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guysi have a 3560 running IOS 'c3560-ipservices-mz.122-25.SEB4.bin'When i connect a cicso ip phone into the port it goes into err-disable. when i do a show power inline f0/19 it says inline power is not supported on this interface. This is the cas...
Hi GuysDoes anyone know how to get EEM to run a ping/trace?Nothing is displayed in the flash if i use the following configevent manager applet BGPDOWNevent syslog pattern "received from neighbor"action 1.0 cli command "enable"action 1.1 cli command "...
Hi GuysI have run into a problem which i just dont understand.If i perform a show ip route i can see a route learnt via ospf in the routing tablecisco#sho ip route 10.231.27.254Routing entry for 10.231.27.0/24 Known via "ospf 100", distance 110, met...
HiFrom what I understand in the show ip bgp x.x.x.x/x output the received-only would be present when soft-reconfiguration inbound is configured and the route has been rejected by a policy i.e. a route mapWhat i have also found is that on many outputs...
Hi Guys,ISAKMP on one of my routers is faililng and im not too sure why. I have narrowed down what the issue may beJan 4 12:21:10: ISAKMP:(0:0:N/A:0): beginning Main Mode exchangeJan 4 12:21:10: ISAKMP:(0:0:N/A:0): sending packet to 208.50.119.163 ...
Hi Giuseppe If I try that command I still can't see that route in the database, i haven't got the option for detail.Am I not right in assuming theses intra area routes must be in the database to be installed in the routing table?cisco#sh ip ospf data...
I see! I just assumed you wont need to map you own local ip address. Now i will be testing this in my lab with incorrect setting, correct settings with debug turned on so i can see whats going on!Thanks!
from the other side i can ping 192.168.1.1 but NOT 192.168.1.2 (its local address!).I was setting up a frame relay configuration and was confused when this happened. I change the configuration to sub interfaces and it just started working, allowing m...
