Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Folks,
how can the qos statistics be reset on the 1gig IA ports of 6880x switch.
I was looking for something similar like we have in catalyst switches as
clear mls qos int g1/0/1 statistics
but couldnt find anything similar. i can see the statist...
Folks,I was testing deployment of easyqos beta of APIC-EM 1.2.0.1594. When i tested it on a 3750x and 2960x, it doesn't completely deploys the QoS. I found some of the class-maps and ACLs empty, plus i couldnt see all 1323 apps being matches in ACLs ...
Hello,I am facing some issues with applying easyqos on a couple of router i.e. 2911 and 2921. Easyqos is policy keeps failing on these router, both are running IOS 15.5M3. Can someone please assist.APIC-EM version is 1.2.0.1594Regards,-KN
Friends,I am trying to discover 2811 and a 1921 router using APIC-EM v 1.2, but unsuccessful. Can you kindly advise if these are supported platforms in APIC?Regards,-KN
Hi there, I have a question regarding the below config:=================================class-map match-any cm-prec-1-outmatch ip precedence 1class-map match-any cm-prec-0-outmatch ip precedence 0class-map match-any cm-prec-3-outmatch ip precedence 3...
Hi Ryan,
I just came searching for something similar to your post. In my scenario, the SVIs are all on the nexus and are not running VRF. and otv is already running for some vlans between a couple of DCs in unicast mode. Now a third party is gettin...
hi Scott,
This doesn't show the client names on which are on guest anchor on the command line. i can see the clients through GUI but not through command line.
WLC version 8.0.152
Regards,
-Khurram
Well, i had some issue in the mobility configuration and the mobility was down some how. when i fixed it, it started working. Yes the anyconnect client works better with the wireless setup.
Thanks for your help!
i am currently having similar issue. my client cannot obtain ip address from the dhcp server. surprisingly the same dynamic interface is allocated to another ssid which is doing webauth and gets ip address. the dhcp option in my case is set to global...
Found this query while searching for the Fallback methods. My WLC is 8.0 and i can see that the time for passive fall back is configurable (default 300sec)
