Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have been trying to get my head around using NETCONF/YANG with IOS-XE. I am particularly interested in polling data. I have enabled Cisco ODM on my device and I show polling is set up. My question is, how to I get to this data via a RPC c...
I have a DMVPN setup as well as another SD-WAN solution. The tunnels for both solutions flow through an ASA for Internet access. I have a problem when one end of the tunnel flaps or briefly goes down, the tunnel will not come back up.
I have narr...
Has anyone gotten Desktop sharing to look good via Jabber (w/o webex)?
According to this bug (CSCuj80610) you cant have decent sharing quality on anything higher than 1024x768. I guess wanting to share at a higher resolution is considered an "enha...
I am trying to setup up a new office in our CUCM 10.5 environment and I am having interdigit timeout issues. Any device/DN ip put into the new partition/CSS etc. has an interdigit timeout when dialing ANY number, including DN's assigned to other par...
I recently have installed ISR-WAAS on a 4451-x. I ran through the EXconfig wizard and from what I can tell everything looks correct. The WAAS is registered in CM and policy has been applied to the device.The problem is when I enable "service-insert...
I am using the cisco-mac-address-table yang model. I had to pull it off the switch as is doesn't seem to be available in the repos.
I am also using cisco-lldp-state for the lldp model.
Yes. Here is the running config on my switch. Getting the interface-state works, but not LLDP-state or the mac-address-table
netconf-yang cisco-odm actions parse.showInterfaces polling-interval 12000netconf-yang cisco-odm actions parse.showMacAdd...
Just to follow up. I believe I figured out the RPC call for the information I am trying to get. The switches just do not return any data. I am trying to get the mac-address-table. I have verified polling is enabled for this parser. I have tried ...
