Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have found a doc on CCO that informed me that there was a problem between my ACS (v3.0) and my Active directory. What I do not understand is i have over 250 machines re-keying every 7 minutes and 99.9 percent work with out fail. Only a very small...
I am here in sunny florida where we have severe lightning storms almost daily. when the Lightning hits close random ports on the switch reset, not all line cards only a few. But all ports on the specific cards reset. The supervisors stay up with n...
We are currently deploying a 3725 solution to our branch offices. We went with the Cisco recomended HDA-FXS card as it would shunt to 1 pair on the interface card to a b1 line in a total power failure so there could still be 1 phone that could have ...
I currently have a full LEAP deployment for my AP350 LAN adapters. I had a non aironet card travel to the LEAP location and I tried to turn on MAC address authentication for that one MAC address. Can I still do MAC auth if LEAP is running full encr...
We have currently purchased a test laptop with the new intel 2100 card that "supports LEAP" Intel Is telling me that drivers must be obtained from Cisco. I have tried teh ACU which obviously does not work being it is not an aironet card. Anyone t...
No we have the 6500 design team looking at the problem. Cisco is claiming to never have heard of this, I guess we are the only 2. I will let you know if I can find anything out.
Oops. Sorry I have a 3870. With a aironet pcmcia card. There are very few companies that support LEAP's proprietary protocol. Some companies are licensing it with cisco. I am facing the same challenge with these built in WLAN (True Moble) cards f...
If you have an aironet card just get the drivers from cco and it gives you the LEAP option. You will have to enable WEP and LEAP in the cisco utility on your ipaq
