About Nicholas Poole

Nicholas Poole · 11-19-2015

The admin guide (http://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-0/administrator/guide/PIAdminBook/monitor-advanced.html) lists 2 tables of dashlet data sources. I am confused by the explanation of one table from the other, espec...

Nicholas Poole · 06-11-2015

How can I check what bandwidth a 4G router think it have other than the 100/50 theoretical interface speed its gets on the line as per the example Cisco configs? All I can see so far is some radio signal information, such as: Router#sh cellular...

Nicholas Poole · 01-30-2015

Is there a MAC address limit for Cisco switches, and if so what is it and where can I find it? There is normally a published MAC limit for Cisco Cat switches, typically of 8K. This is listed in the respective data sheets. I haven't found anything i...

Nicholas Poole · 10-14-2014

Has anyone ever got the following doc example to work? I have changed it from shutdown a port to change the description as otherwise I would lose access to my switch (high quality example there Cisco) but nothing is deployed. I have created an inte...

Nicholas Poole · 08-20-2014

After an upgrade to 1.2.1, I now see a lot of auth failed entries with an Identity/Endpoint ID of 00:00:00:00:00:03.I dont see this MAC on the switch port of the NAS where ISE reports it. Anybody know what this is and how to stop it from happening? t...

Nicholas Poole · 01-30-2015

Your view matches mine, which is that as the (ISR) router is more software than hardware ASIC specific as a Cat switch would be its upper limits are probably not as well defined or recorded. I just wonder if anyone has actually got any real world exp...

Nicholas Poole · 10-28-2014

Do you have ACL restrictions on SNMP to allow only your servers?Do you have CoPP enabled?

Nicholas Poole · 10-20-2014

Thanks for the reply. Im aware that there are still gaps between LMS and Prime, I didn't see the ability to push a config to a port group as being a compliance feature, but I see what you are saying. What I don't get though is that your link (thanks...

Nicholas Poole · 10-14-2014

Did you get anywhere with this? I want to do something similar, configure just some ports, not all ports. Prime seems to work by deploying templates to device groups, but I want it to deploy by device and port groups. Sadly it seems port groups ar...

Nicholas Poole · 10-14-2014

Did you get anywhere with this? I want to do something similar, configure just some port, not all ports. Prime seems to work by deploying templates to device groups, but I want it to deploy by device and port groups. Sadly it seems port groups are...

Member Since	‎01-25-2006 03:37 AM
Date Last Visited	‎02-05-2021 03:06 AM
Posts	154
Total Helpful Votes Received	68

User Statistics

User Activity

Prime Infrastructure Dashlet Data Sources - Top N Clients

How to check what the attainable rate/dynamic bandwidth of a 4G LTE link?

cisco router mac limit?

Cisco Prime using Database Variables in CLI Templates

ISE 1.2.1 logs full of Identity/Endpoint ID of 00:00:00:00:00:03, authentication failed

Your view matches mine, which

Do you have ACL restrictions

Thanks for the reply. Im

Did you get anywhere with

Did you get anywhere with