Hello,
I am trying to create a SNMP ACL on a Nexus 9K. Previously I have created them using command similar to:
snmp-server community MyCommunityString RO 1
However, from what I can gather on the new commands, I have the following created to tr...
Hello,We currently have a cisco 2911 and have been handed a 1000/Mb single mode fiber with an ST connector from our service provider. I am not able to find any modules that support this type of interface for our router (most of them are LC). I dont h...
Hello,I have a cisco 3560 L3 switch. The 4 GBIC slots are configured as trunks and are behaving as needed. However, this is a 48 port switch and have exhausted our ports so would like to attach another 24 port to it. I am trying to configure port 48 ...
Hello,I am somewhat new to the fiber world and would appreciate some direction on how to proceed on some confusion I have.We have an ISP who is handing off the connection in single mode fiber (LX) at 10 MB with an ST connector. We have a 2911 on site...
Hello All,I am a confused about the process of upgrading and licensing afterwards.For example, I currently have a 3560G switch running c3560-ipservicesk9-mz.122-58.SE2I have a spare 3560 V2 switch I want to configure and have ready in case of a failu...
Tom,Thanks for the reply. The connection is an MOE circuit and most of our other sites are 10 Mb as well. However, the handoff for the other sites are copper so I have never experienced this scenario before. Thanks.