Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Image: C3750e-ipbasek9-mz.122-58.SE2.bin"Two stacks of 4 switches eachEach stack has one module : C3KX-NM-10GTSo I could create a 20--GBit erherchannel. But what If I want to create a 22-Gbit etherchannel?Could I use the Two(2) 10-Gbit interfaces on ...
I am trying to get into ROM mode into this 2500 router but there is not display of anything and then shows the message "Press RETURN to get started" all of the boot up information from boot loader is not displayed. I send the ctrl-break but nothing h...
SOURCE: https://supportforums.cisco.com/docs/DOC-1268#Allow_specific_urlsHi all,I have the following configuration in my ASA based on guidelines from the above source to allow only certain sites in my home and block all requests to http and https si...
Pix 515 6.3.5I have this configurationstatic (outside,inside) 1.1.1.1 192.168.1.1access-list ACL permit tcp any host 1.1.1.1 eq httpsIn this case all users from OUTSIDE can access the server by IP 1.1.1.1Because of a special case that I do not want t...
CISCO ACS 5.3Using external data identity store: ADHi all,Is there a way to lock down the authentication to one AD group only ?In access policies authorization can be restricted to a group only but I cannot find a way to do it with authentication. Fo...
Thanks Joseph.We currently have a 2-GB etherchannel between those two stacks. so what I might do is to set up a new 20-GB etherchannel and let STP take care of keeping the 2-GB link in passive mode.Juan
Thanks Ankur. We currently have a 2-GB etherchannel between those two stacks. so what I might do is to set up a new 20-GB etherchannel and let STP take care of keeping the 2-GB link in passive mode.Juan
Thanks Leo. I figured that was the answer "All LAN ports in each EtherChannel must be the same speed, and you must configure all the ports as either Layer 2 or Layer 3 LAN ports." according to the link provided by Ankur.We currently have a 2-GB ether...
Disregard the question. I unplugged the power cable and let it setting all night. Still did not work, then I changed it from a power outlet and it worked. Go figure. Not related to baud rate or anything like that. real strange
