Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, If we have a CUCM-VCS integration for internal and outside calls via CTS/TX9000 end-points , does it applicable to TX9000 - TX9000 intercompany calls also, or do we still require B2B exchange integration for calls between two different compa...
Hi All,Wonder if someone has experience on QoS configuration specific to CTS Telepresence and able to answer on my below query :********************************** I am trying to understand how can we check the QoS configuration applied on CTS's :- If...
Hi All,Wonder if someone has experience on QoS configuration specific to CTS Telepresence and able to answer on my below query :********************************** I am trying to understand how can we check the QoS configuration applied on CTS's :- If...
Hi All,I am trying to understand how can we check the QoS configuration applied on CTS's :- If I go to Telephony settings in CTS, it gives me :DSCP For Audio: EF DSCP (101110) DSCP For TelePresence: CS4(precedence 4) DSCP (100000) I was under impress...
Hi All,I had a Cisco 7975 IP Phone registered in CUCM, I edited the device pool name and region name associated with that IP phone today and since then the IP phone registration is dropping intermittently.I tried to give it a re-start few times but n...
I posted it on both the forums with the thought that different people view and address them..... I thought you directed me to the answer, but sadly, it was my post on different section of this community.
Hi Nick,Thanks for your reply.As you mentioned, I re-started the CTI service and booked a new meeting, but as client was out of business hours ..I couldn't get chance to confirm the status on IP Phone/Touch panel and while countinuing my investigatio...
Hi Dale,I have shut down the CTS Manager and tried to book the meeting on TMS, but still it's not pushing onto the CTS end-points or MX300 end-points..The version on CTS is : CTS 1.8.3(4) The version on MX300 : TC5.0.1.275220 TMS : 13.2.1When I book ...
Hello, I am going to remotely shut down the CTS manager for this client, but at the moment, there are few recurrsive meetings showing on CTM for year 2013 and 2014 which are in error as just included one CTS room, all these meetings are already been ...
