Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having an issue with call fowarding a shared line to another extension. Extension x3044 is on 4 different phones as a shared line with the same settings on each phone for this line. Currently I have an extension (3044) set to foward to (1123) on...
Hello everyone:I have a problem that i can not seem to figure out. What I basically have is a Comcast cable modem connected to a 3524xl switch port that is trunked. I then have a 2620xm w/ 1FE port that is plugged into another trunked port on my 3524...
Hello everyone i am new to Cisco and just started studying for my CCNA. I have a 1751v router and a 2924xl switch. I have the LAN setup correctly but for some reason the WAN on my router will not connect. I have it set up on DHCP from my ISP which it...
Rob--I tried as you suggested and I am still being presented with the call flow going haywire when I set the FNA timer to anything above 12 seconds. I did make one change though and put x3044 as line 1 on 1 of the phones to see if this would make a ...
Rob--x1123 is not set to forward anywhere. x3044 is set to forward to x1123 on Forward No Answer Internal/External. My understanding was that when a call came in on the originating extension and is forwarded to another extension and not answered the...
Nagaraja and Mike-So basically the runts that i am seeing accumulating on my switch port is nothing to be concerned about then? All responces i have tried and still show the runts accumulating. If this is the case then that is good. My network dont s...
