I am trying to prevent rogue dhcp request from bringing down my network.
My dhcp servers are not local to the network
But helpers/proxy over the firewalls and local core to a real dhcp servers at our data center.
Core is layer three ... dhcp serve...
Over our hard wired systems it works fine now but over wi-fi we can't get the airplay icon to be there. I have configured the wlc with multicast per documentation http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_tech_note09186a0080bb1d...
I would like to convert some 1142N LAP to Autonomous. Is there a way to do ?I have noticed a new image : c1140-k9w7-tar.124-25d.JA.tarI don't see a way to replace the image in flash .... ?
The users on the 10.205.64.0/24 subnet.
We migrated to another firewall and it worked after we did.
So something was stuck on the firewall from making it work and I didn't have a compelling reason at the time to pull out all the nats and put them...
I did it this past weekend. With routing enabled on both layer 3 switches it seemed to be better to assign another segment vlan between them especially because of the bendavis device. Even though I was trunked between newman and Olinger it still did ...
Logicly what is the distinction ?I still have to create a vlan database entry for the vlan 17 on both switches then create a interface vlan 17 entry on both switches and trunk the two fibre interfaces between the two. Then configure the 2950g for vla...